Knowledge Test Class B
This license is required for driving a single vehicle with a GVWR of more than 26,001 pounds, and a trailer not to exceed 10,000 pounds gross vehicle weight rating, or a vehicle designed to transport 24 or more people (including the driver). To receive this license, applicants must pass a 50-question test. To pass, applicants must answer 40 questions correctly. Each question has three or four possible answer choices. Test questions come from the Wyoming Driver License Manual for Commercial and Heavy Vehicles. Questions come from chapters covering: Introduction, Driving Safely, Transporting Cargo Safely, Air Brakes (if applicable), Pre-Trip Vehicle Inspection Test, Basic Vehicle Control Skills Test and On-Road Driving.. Endorsements that may be used with a Class B CDL are: Hazardous materials, Tank, Passenger, HazMat and Tank, Air Brakes and School bus.
43. In a vehicle with dual parking control valves, a separate air tank can be used:
In a vehicle with dual parking control valves, there is a separate air tank that can be used to temporarily release the spring brakes if they have been activated due to low air pressure. Pushing in the proper control will release the spring brakes for a short period of time, allowing the driver to move the vehicle in an emergency.
44. When checking your tires as part of the pre-trip inspection, you should look at the:
When checking your tires as part of a pre-trip inspection, it is important to verify that the tire pressure is neither too low nor too high.
45. A tank endorsement is:
With some exceptions, you must have a tank endorsement to transport liquids or gases. This applies to both hazardous and non-hazardous substances.
46. When making a tight maneuver, you should:
Make a point of checking your mirrors often when making tight maneuvers.
47. What should happen if the air pressure in the air brake system tanks falls below 60 psi?
On vehicles with air brakes, a low air pressure warning signal will come on if the pressure in the air tanks falls below 60 psi. On large buses, the signal may activate at 80 to 85 psi.
48. If involved in an accident, which of the following is not recommended?
When involved in an accident, you should protect the area, notify authorities, care for the injured, collect required information, and report the accident. You can lose your license for leaving the scene of an accident.
49. Blocking is used to:
Blocking and bracing are used to prevent cargo from sliding in transit.
50. When conducting a pre-drive inspection:
The first step of a vehicle inspection is to review the last vehicle inspection report. Only sign the report if noted defects are certified to have been repaired.
Ranked by best match
Frequently Asked Questions
1. Obtain a Wyoming Commercial Learner's Permit (CLP): You must be at least 18 years of age, possess a valid Wyoming driver's license, and pass a series of written tests related to commercial driving. You must hold the CLP for at least 14 days before taking the road skills test.
2. Practice driving: During the 14-day waiting period, you must practice driving with a CDL holder who has the same class license you are seeking.
3. Schedule and pass the road skills test: Once you have held the CLP for at least 14 days, you can schedule and take the road skills test. You will need to provide your own vehicle for testing and it must meet certain requirements.
4. Pass a medical examination: You must pass a medical examination by a certified medical examiner to obtain your CDL.
5. Submit required documents: You will need to provide proof of identity, residency, and social security number. You will also need to provide any necessary endorsements or certifications.
6. Pay the required fees: There are various fees associated with obtaining a CDL in Wyoming, including application fees and testing fees.
7. Receive your Class B CDL: Once you have completed all of these steps, you will receive your Class B CDL license in Wyoming.
1. Large buses, such as school buses or city transit buses
2. Straight trucks, such as delivery trucks or dump trucks
3. Box trucks and cargo vans with trailers
4. Tow trucks and other similar vehicles used to transport heavy equipment
5. Motorhomes and recreational vehicles (RVs) that exceed 26,000 pounds.
It's important to note that if you want to operate hazardous materials (HazMat) or passenger-carrying vehicles, you will need to obtain additional endorsements on your CDL license.
1. Be at least 18 years of age: You must be at least 18 years old to obtain a Class B CDL license in Wyoming. However, you will be restricted to driving within the state of Wyoming if you are under 21 years of age.
2. Possess a valid Wyoming driver's license: You must have a valid Wyoming driver's license to apply for a CDL.
3. Pass a written knowledge test: You must pass a series of written tests related to commercial driving, including general knowledge, air brakes, and combination vehicle tests.
4. Obtain a Commercial Learner's Permit (CLP): After passing the written tests, you must obtain a CLP, which allows you to practice driving with a qualified CDL holder.
5. Pass a road skills test: You must pass a road skills test that includes vehicle inspection, basic vehicle control, and on-road driving.
6. Pass a medical examination: You must pass a medical examination by a certified medical examiner to obtain your CDL.
7. Provide required documents: You will need to provide proof of identity, residency, and social security number. You will also need to provide any necessary endorsements or certifications.
8. Pay the required fees: There are various fees associated with obtaining a CDL in Wyoming, including application fees and testing fees.
It's important to note that if you have committed certain offenses or have certain medical conditions, you may be disqualified from obtaining a CDL license.
If you are 21 years old or older, you can drive across state lines with a Class B CDL license. However, certain endorsements, such as HazMat or passenger endorsements, may have additional age requirements. It's important to check with the Wyoming Department of Transportation for specific requirements related to your CDL license and endorsements.
In Wyoming, the following endorsements are available for Class B CDL drivers:
1. Air Brakes (required for any vehicle equipped with air brakes)
2. Combination Vehicles (required for any combination of vehicles with a total weight of 26,001 pounds or more)
3. Hazardous Materials (required for drivers who transport hazardous materials)
4. Tank Vehicles (required for drivers who transport liquids or gases in tanks)
5. Passenger Transport (required for drivers who transport 16 or more passengers, including the driver)
6. School Bus (required for drivers who operate a school bus)
If you will be driving a Class B vehicle without air brakes and not carrying hazardous materials, passengers, or tank vehicles, you may not need any endorsements. However, if you will be driving any of the above-mentioned vehicles or carrying certain types of cargo, you may need to obtain the appropriate endorsements in addition to your Class B CDL license.
1. Pre-Trip Inspection: You will be required to conduct a thorough inspection of your vehicle to ensure that it is safe to operate. You will need to identify and explain the various components of the vehicle and how they should be inspected.
2. Basic Vehicle Control: You will be evaluated on your ability to control the vehicle in a variety of different situations. This includes tasks such as backing up, turning, and parking.
3. Road Test: You will be evaluated on your ability to safely operate the vehicle in traffic. This includes tasks such as merging, changing lanes, and driving in various road conditions.
During the skills test, you will need to demonstrate proficiency in each of these three areas. You will be graded on a point system, with deductions for errors such as hitting cones or curbs, failing to signal, or not following proper procedures.
It is important to note that the skills test must be conducted in a vehicle that is representative of the Class B vehicle you will be driving. If you plan to drive a vehicle with air brakes, you must take the test in a vehicle with air brakes. If you plan to transport passengers or hazardous materials, you must take the appropriate additional tests.
1. Passenger Transport: If you have a Class B CDL with a passenger transport endorsement, you may only operate vehicles designed to transport 16 or more passengers, including the driver.
2. Hazardous Materials: If you have a Class B CDL with a hazardous materials endorsement, you may only transport materials that are classified as hazardous.
3. Air Brakes: If you do not have an air brake endorsement, you may not operate vehicles equipped with air brakes.
4. Tank Vehicles: If you do not have a tank vehicle endorsement, you may not transport liquids or gases in tanks.
5. Automatic Transmission: If you took your skills test in a vehicle with an automatic transmission, your license will be restricted to vehicles with automatic transmissions only.
6. Intrastate Only: If you do not meet the federal medical requirements for interstate driving, your license may be restricted to intrastate (within Wyoming) only.
It is important to note that these restrictions and limitations may vary depending on the specific endorsements and qualifications on your CDL license. Be sure to check with the Wyoming Department of Transportation for more information on your specific situation.
However, if you have difficulty reading or understanding English, you may be able to bring an interpreter with you to the DMV office to assist you during the written test. The interpreter must be fluent in both English and your preferred language, and they must provide identification and sign an affidavit stating that they will accurately interpret the questions and answers on the test.
It is important to note that if you plan to operate a commercial motor vehicle outside of Wyoming, you will need to be able to communicate effectively in English, as it is the language used for communication between drivers, dispatchers, and law enforcement officers across the country.
To request accommodations, you will need to complete the Request for Accommodation of Disability form and submit it to the Wyoming DOT along with documentation from a qualified healthcare professional that describes your disability and explains why you need accommodations.
The Wyoming DOT will review your request and determine what accommodations are appropriate based on your specific needs. Some examples of accommodations that may be provided include extra time to complete the test, a separate testing room, or an interpreter or assistive technology.
It is important to note that you must submit your request for accommodations at least 30 days before your scheduled test date in order to allow sufficient time for the Wyoming DOT to review and process your request.