Knowledge Test Class A
This license is required for driving any legal combination of vehicles, with a gross combination weight rating of 26,001 pounds or more, provided the GVWR of a trailer exceeds 10,000 pounds To receive this license, applicants must pass a 50-question test. To pass, applicants must answer 40 questions correctly. Each question has four possible answer choices. Test questions come from the Kansas Commercial Driver License Manual. Questions come from chapters covering: Introduction, Driving Safely, Transporting Cargo Safely, Air Brakes (if applicable), Combination, Doubles and Hazardous Materials. Endorsements that may be used with a Class A CDL are: Hazardous materials, Tank, Passenger, HazMat and Tank, Air Brakes and School bus.
1. Steering wheel play should be no more than:
Steering wheel play of more than 10 degrees (about two inches of movement at the rim of a 20-inch steering wheel) can make it difficult to steer.
2. When a construction worker is close to the road, you should:
In construction zones, do not exceed the posted safe sped limit. Slow down even more when workers are near the roadway.
3. When driving through a work zone, you should:
In work zones, you should observe posted speed limits. Slow down if road or weather conditions are poor, and slow down even further if workers are near the roadway.
4. Extremely hot temperatures can cause:
Because air expands when hot, tire pressure increases as temperatures increase. This can sometimes result in tire failure. Consistently check your tire pressure when making a trip in hot weather.
5. The suspension system:
The suspension system holds up the vehicle and its load while keeping the axles in place. Damage to a suspension system can be very dangerous.
6. An air compressor governor will stop the compressor from pumping air once the air tanks have an air pressure level of:
An air compressor governor will stop the compressor from pumping air once the air tanks are at an air pressure level of 125 psi. This air pressure level is referred to as the "cut-out" level.
7. Before beginning downhill, you should:
On a steep downgrade, you must use the engine's braking effect as your primary method of speed control. Be sure to decelerate and downshift appropriately before beginning to drive down the hill. Relying too heavily on the brakes may cause them to overheat and fade, becoming less effective.
Ranked by best match
Frequently Asked Questions
To obtain a Class A CDL in Kansas, you must meet the following requirements:
1. Be at least 18 years old to operate within the state of Kansas and 21 years old if you plan to drive across state lines.
2. Possess a valid Kansas driver's license.
3. Pass a vision test.
4. Obtain a medical certificate from a licensed medical examiner.
5. Pass the written knowledge test for the Class A CDL.
6. Pass the skills test for the Class A CDL.
7. Provide proof of US citizenship or lawful permanent residency.
It is important to note that additional endorsements may be required for certain types of vehicles or cargo, such as hazardous materials or passenger transport.
In addition to the Class A CDL license, you may need specific endorsements to operate certain types of vehicles or cargo. For example, you may need a hazardous materials endorsement to transport dangerous materials or a passenger endorsement to transport passengers.
It is important to note that each state has different rules and regulations regarding CDL licenses and endorsements. Therefore, it is important to check with the Kansas Department of Revenue - Division of Vehicles for specific requirements and regulations.
1. Be at least 18 years of age to operate within the state of Kansas and 21 years of age if you intend to drive across state lines.
2. Possess a valid Kansas driver's license.
3. Pass a vision test.
4. Obtain a medical certificate from a licensed medical examiner.
5. Pass the written knowledge test for the Class A CDL. This test evaluates your knowledge of the rules and regulations for commercial driving, including safety procedures, pre-trip inspections, and driving techniques.
6. Pass the skills test for the Class A CDL. This test involves three parts: pre-trip inspection, basic vehicle control, and on-road driving skills.
7. Provide proof of U.S. citizenship or lawful permanent residency.
8. Pay the appropriate fees.
It is important to note that additional endorsements may be required for certain types of vehicles or cargo, such as hazardous materials or passenger transport.
It's important to note that some employers may have their own age requirements for hiring commercial drivers. Additionally, drivers under the age of 21 may face restrictions on the types of cargo they can transport and the hours they can work. Therefore, it's important to check with the Kansas Department of Revenue - Division of Vehicles and any potential employers for specific age requirements and restrictions.
1. Hazmat endorsement: This endorsement is required if you will be transporting hazardous materials. You must pass a written exam and meet additional requirements, such as passing a background check and completing fingerprinting.
2. Tanker endorsement: This endorsement is required if you will be transporting liquids or gases in bulk containers. You must pass a written exam that covers knowledge of tanker operations, safety, and regulations.
3. Doubles/Triples endorsement: This endorsement is required if you will be towing double or triple trailers. You must pass a written exam that covers knowledge of safe driving practices and handling multiple trailers.
4. Combination of Tank Vehicle and Hazmat endorsement: This endorsement is required if you will be transporting hazardous materials in bulk containers. You must pass both the Hazmat and Tanker endorsements.
It's important to note that some endorsements may have additional requirements, such as completing specialized training or providing proof of work experience. It is best to check with the Kansas Department of Revenue - Division of Vehicles for specific requirements related to your endorsements.
1. Pre-Trip Inspection: In this part of the test, you will be required to inspect your vehicle to ensure it is safe to operate. You will need to demonstrate your knowledge of the vehicle components and how to check them, such as brakes, steering, lights, tires and more.
2. Basic Vehicle Control: In this part of the test, you will be required to demonstrate your ability to control your vehicle in a controlled environment. You'll be tested on basic maneuvers such as straight-line backing, offset backing, parallel parking and more.
3. On-Road Test: In this part of the test, you will be required to demonstrate your ability to safely operate your commercial vehicle in typical traffic situations. You'll be tested on your driving skills such as accelerating, braking, turning, changing lanes and more.
During the test, you will be graded by a licensed examiner who will evaluate your performance based on a set of criteria established by the Kansas Department of Revenue - Division of Vehicles. If you pass all three parts of the skills test and meet all other requirements for a Class A CDL, you will be issued a CDL license.
1. Air Brake Restriction: If you take the skills test in a vehicle without air brakes, you will be issued a CDL with an air brake restriction. This means that you are not authorized to operate a vehicle with air brakes.
2. L and Z Endorsement Restriction: If you take the skills test in a combination vehicle without a double or triple trailer, you will be issued a CDL with a restriction that prohibits you from operating a combination vehicle with double or triple trailers.
3. Intrastate Only Restriction: If you do not meet the requirements for interstate commerce, your CDL will only be valid for operating commercial vehicles within the state of Kansas.
4. Medical Certification Restriction: If you do not maintain a valid medical certification, your CDL may be restricted or suspended.
It's important to note that there may be other restrictions or limitations based on your driving record or specific circumstances. It's best to check with the Kansas Department of Revenue - Division of Vehicles for specific information related to your situation.
To request accommodations, you must complete and submit the "Request for Reasonable Accommodations" form to the Kansas Department of Revenue - Division of Vehicles. The form requires documentation from a qualified medical provider that supports your need for accommodations. Some examples of accommodations that may be provided include extended testing time, alternate testing formats, and special equipment or software.
It's important to note that requests for accommodations must be submitted in advance of the test date to allow time for processing and arrangements. The Kansas Department of Revenue - Division of Vehicles will work with you to determine appropriate accommodations based on your specific needs.
In Kansas, you are allowed to take the Class A CDL written test up to three times within a 12-month period. If you fail the test three times, you must wait at least 30 days before taking it again. Additionally, if you fail the test, you will need to pay the testing fee again when you retake the exam.
It's important to note that while there is no limit on how many times you can retake the Class A CDL written test overall, there are limits on how frequently you can take it in a short period of time. It's recommended that you study and prepare thoroughly before retaking the test to increase your chances of passing on subsequent attempts.